Introductions
Congratulations on your purchase of the TeleDoorBell, a system that offers enhanced security while providing
unparalleled convenience. The system can be used with or without a doorbell.
Operation is subject to the following Conditions:
1) This device may not cause harmful interference
2) This device may accept any interference including interference that may cause undesired operation.
Complies with Part 68, FCC Rules FCC REG NO. 5ERCAN-31264-OT-N REN: 0.8B
(DOC/CSA/UL approved)
Features
The TeleDoorBell is a telephone based doorbell system that provides the system user with the capability of
communicating with a door speaker from any installed telephone set, including cordless. Unmatched in convenience, this
unique new product provides the following features:
* System will work as a replacement or in parallel with any standard doorbell.
* Provides high-quality audio conversation capability with any connected door speaker.
* Unique telephone ringing when door speaker button depressed.
* Allows homeowner to select the door speaker by entering a unique touch-tone code from any telephone.
* Will provide toll restriction at the discretion of the owner.
* Rings telephones distinctively when door speaker button depressed.
* Relay closure to ring doorbell or a number of other devices.
* Can be set to ring doorbell only.
* Door speaker has LEDs for constant illumination.
* Supports speakerphone quality conversation between the telephone and the door speaker.
* The system gives a user two minutes to access door following the depression of the door speaker button.
* If the door speaker button is depressed, when the telephone is in use on an outside call, the user hears a beep
tone to alert that there is a visitor at the door. The user can then depress
*4
on a touch-tone telephone to put the
telephone call on hold and connect to the door speaker. Depressing
*4
again will return to the telephone call.
Note: this can only be used once and only after the door speaker button is depressed. Alternatively, a user can
hang up on the telephone call and then pick up the handset and they will be connected to the door speaker. (This
needs to be done within the two minute window. # can be used beyond the two minutes).
* *
* A DTMF code selection (dialed from any connected telephone) allows the system user to access the door speaker
outside of the two-minute window.
* Relay closure activated by DTMF digit
*5
or
*8
allows door strike dry contact operation. (Normally Open NO).
* Toll Restriction, 1+ long distance, 011 international, or 1+976, user programmable.
* Password protection for programming which user can change to a personal 3-digit DTMF code.
* Progress tones to guide user while programming.
Parts list
The TeleDoorBell system is shipped from the factory with the following components:
* TeleDoorBell control unit
* Speaker Unit with wall mounting plate
* CSA/UL approved class 2 Power Supply, Input 120VAC, 60Hz, Output 16Vac 250 mA. Note the system will also
work with a class 2 Power Supply Input 120VAC, Output 16-24Vdc 350 mA. Please make sure that the output
does not exceed 24 VDC or serious damage may occur.
* Two (2) modular RJ-11 Male open-ended patch cord. Used to splice and connect door speaker unit, door strike
and doorbell, to the TeleDoorBell system unit.
* RJ-45 8 pin male to male modular patch cord.
* Three (3) #6 wood screws for mounting
* Dimensions: Controller (17cmX17cmX4cm) Door-speaker (15.5cmX10.5cmX3cm)
Page 3
