background image

For best results use only  

authentic Logan blades

INSTRUCTION MANUAL

MODEL T100

CRAFT MATERIALS 

CUTTER

INSTRUCTIONS AND OPERATION MANUAL 

32in (81cm) capacity materials cutting system 

with fixed and rotary cutters. 

Uses Logan Replacement 

Blades 270 and T10

L2335   12-16

Purchase Date

ID Number (on bottom of board)

Date (on bottom of board)

LoganGraphic.com

CAUTION!!  

CUTTING BLADES ARE SHARP

Summary of Contents for T100

Page 1: ...RIALS CUTTER INSTRUCTIONS AND OPERATION MANUAL 32in 81cm capacity materials cutting system with fixed and rotary cutters Uses Logan Replacement Blades 270 and T10 L2335 12 16 Purchase Date ID Number on bottom of board Date on bottom of board LoganGraphic com CAUTION CUTTING BLADES ARE SHARP ...

Page 2: ... including insurances shall be borne by the purchaser Logan shall not be liable for any damages or losses incidental or consequential direct or indirect arising from the use of this product This warranty extends only to the original purchaser and is not assignable or transferable This warranty is in lieu of all other warranties expressed or implied Be advised that any Logan products purchased as n...

Page 3: ...place nut Squaring Bar Assembly 1 Align squaring bars over board slots Fig 4 2 Press bars into slots Preparation Rotary Knife Fig 5 1 Loosen safety screw one full turn it will allow safety cover to pivot 2 After cutting tighten safety screw to lock safety cover over blade Fixed Knife Fig 6 1 Loosen knob 2 Adjust blade depth 1 16 setting chipboard posterboard matboard 3 16 setting cardboard foamboa...

Page 4: ...one pass may be needed Maintenance Cutting Bar Wear After prolonged use the cutting bar may need to be changed All four sides of the bar can be used before replacement Order replacement part P2331 Cutting Bar To Change 1 Lift cutting bar out of slot Fig 12 2 Rotate 180 Fig 13 3 Slide bar back into slot aligning hole in bar with pin in slot Fig 14 4 To use other sides of cutting bar completely remo...

Reviews: