Framer’s Edge Elite Mat Cutter
Instruction Manual
Model 650-1 / 655-1 / 660-1
11
Logan Graphic Products Inc., 1100 Brown St, Wauconda, IL 60084 847-526-5515 [email protected]
LoganGraphic.com
Mat Guide
#602 Slide
#603 Wedge
#604 Mat
Guide
Screws (2)
#112N Mat
Guide Knob
Mat Guide Assembly
If mat guide wedge becomes unscrewed from mat guide, reassemble making sure
angle of wedge is aligned correctly.
(Fig. 37)
Re-parallel Mat Guide
Tools Needed: Phillips Screwdriver, Ruler
To re-parallel the Mat Guide, first determine that the Mat Guide is out of parallel by
doing a parallel test.
Parallel Test:
1. Lock the Mat Guide at the 2” mark on the scale.
2. Place a scrap piece of matboard under the Guide Rail and up against the Mat
Guide at the far end of the machine.
3. Using a pencil, mark a line across the matboard.
4. Slide the mat all the way down near where you are standing keeping under the
Guide Rail.
5. Mark another line across the matboard.
6. The piece of matboard should now appear to only have one single line across it.
If the two lines drawn do not line up with each other, the Mat Guide needs to be
re-paralleled.
To Re-parallel:
1. Release the Mat Guide.
2. Use a Phillips head screwdriver to loosen the four screws on either side of the
black knobs one turn.
3. Place a ruler or straight edge between the Mat Guide and the Guide Rail.
(Fig. 38)
4. Slide the Mat Guide against the straight edge and the Guide Rail. Make sure
both the Mat Guide and the Guide Rail are making solid contact on both
sides of the straight edge.
5. Re-tighten the Black Knobs first.
6. Then re-tighten the four screws. Do another parallel test to ensure that the Mat
Guide is now parallel.
Fig. 37
Fig. 38
