Saw Fence Kit
Instruction Manual
Model F100-5
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 847-526-5515 www.logangraphic.com
2
• 36” – 48” Straight Edge or Level
• 9/64” Drill Bit
• Phillips Screwdriver
• 3/8” Open End Wrench
• Pencil
• Tape Measure
• Board – 1/2” x 12” x 80” MDF or
Plywood Board (Optional)
• Plastic Clamp (Optional)
• Power Drill
• Utility Knife
Tools Needed
1. 53” Left Fence
2. 27” Right Fence
3. Stop
4. Extension Stop
5. Scale Setting Gauge
6. Allen Wrench
7. Marking Label
8. Screws (8)
9. Scale A
10. Scale B
Parts List
1
9
10
3
4
7
5
6
8
2
WARRANTY:
Logan Graphic Products, Inc. (“Logan”) warrants the F100-5 SAW FENCE KIT to be free from defects in
parts and workmanship for a period of two years from the date of original purchase. Logan warrants that it will either
repair or replace, in its sole discretion, any necessary replacement parts found to be defective. Should the product need
to be returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing.
Costs of returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be liable
for any damages or losses, incidental or consequential, direct or indirect, arising from the use of this product. This
warranty extends only to the original purchaser and is not assignable or transferable. This warranty is in lieu of all other
warranties, expressed or implied. Be advised that any Logan products purchased as “new” from an unauthorized
dealer, such as an online auction site or similar, may be void of their warranty. Logan Graphic Products, Inc., 1100
Brown Street, Wauconda, IL 60084 800-331-6232 847-526-5515
A. Set Fence Height
1. Align one end of fence with edge of saw base. (Fig. 1, Fig. 2)
2. Set height by holding down bracket and adjusting fence until even with base. (Fig. 3)
3. Align and set height of other end of fence. (Fig. 4)
4. Recheck first fence setting, adjust if necessary.
5. Tighten bracket screws with allen wrench. (Fig. 5)
B. Mount Saw
1. Mount saw directly to table or a board.
2. If you are using a board, MDF or high quality plywood is recommended, 1/2” to 3/4”
thick, cut to 12” x 80”. (Fig. 6)
a. Mount the saw 28” from right end of board for fences to fit. (Fig. 7)
Fig. 1
Right
Left
Fig. 2
Fig. 3
Fig. 7
28”
Fig. 5
Fig. 6
80”
12”
Fig. 4
