LOFTNESS 88BHS41T1.S, Manual

Page: 26 / 82

14 Battle Ax H Series OM
Remove Shipping Stand
A stand (1) is secured to the Battle Ax to keep it stable
during shipping. This can be removed after the pusher
bar has been moved to the operating position.
NOTE: Do not discard the shipping stand and hardware.
It is used to stabilize the Battle Ax during storage.
Keep in a secure location until ready to store.
Pusher Bar Assembly (Cont’d)
Fixed Pusher Models (Cont’d)
2
1
5
3
4
A B C
Move the rear arm (1) into position so the hole in the
lower end of the arm aligns with the top hole (2) of the
side plate (indicated by the shipping tag). Remove the
shipping tag.
NOTE: The pusher bar is factory-set so the upper hole
in the rear arm aligns with hole “A”. If a different
pusher bar angle is desired, remove nut and bolt
(3) from their current position while holding on to
the rear arm (1). Once the hardware is removed,
let the rear arm rest on pusher bar side assembly
(4).
Repeat procedure on other side of the Battle Ax.
Raise or lower the pusher bar and align the rear
arm (1) with the desired hole (A ,B, or C) on the
pusher bar side assembly.
Reinstall all hardware and tighten (2, 3, and 5) securely.
This must be done on both sides.
Remove lifting device.
Set-up Instructions