LOFTNESS 51CCH, Owner'S Manual And Parts Book

Page: 25 / 74

15 Carbide Cutter OM
Pusher Bar Adjustment
NOTE: Adjusting the pusher bar requires two people or
the use of an approved lifting device to support
the push bar as it is being adjusted.
Remove bolt (1) and bushing (2) from the lower storage
position. Loosen the two bolts (3 & 4) to allow the pusher
bar to pivot forward (on both sides).
Move the pusher bar forward.
Align the rear arm (1) with the second hole from the front
as shown.
Install bushing and bolt (2) and tighten securely against
the frame. Tighten bolts (3 & 4).
Adjusting the Support Stands
Remove the two bolts (1) and support stand (2). Repeat
procedure on opposite side.
NOTE: Mounting holes (3 & 4) will be used when the
support stands are in the operating position.
Move the support stand up. Install bolts (1) and tighten
securely against the support stand. Repeat procedure on
opposite side.
NOTE:
Install the support stands in the lower position
when storing the carbide cutter.
Set-up Instructions
Approved
Lifting Device
4
1 2
3
3
1
2
1
2
4
3
4