Function
Details
Short Circuit
Protection
Reverse
Connection
Protection
Reverse
Charge
Protection
Input Low /
High Voltage
Protection
High
Temperature
Protection
The red light is always on when the clamp
is short-circuited, the buzzer sounds long,
and the protection can be automatically
released after the fault is removed.
If the clamps are not connected to the
correct positive and negative terminals,
the light will turn red and the buzzer keeps
beeping for a short time. The protection
can be automatically released after
troubleshooting.
The output is automatically disconnected
during reverse charge protection, and the
traffic lights flash alternately. The
protection can be automatically released
after the fault is removed.
If the clamps are connected to the start
port which is higher or lower voltage, the
protection function will be triggered and
the red light is always on.
The clamps will automatically be
disconnected when it is hot(≥80 ºC±10 ºC),
and the light will keep showing red; when
the temperature of the clamp is lower
than 70 ºC, the protection is automatically
released.
07
08
Charging and Recharging
1.) Charge your phone or other devices
2.) Recharge your jump starter
3.) Short press again, shifting to Strobe mode (fast flickering).
4.) Long press the function button to turn off the light.
How to use LED flashlight?
1.) Long press the function button for 3s to turn on the
constant light.
2.) Then short press the function button, shifting to the SOS
mode (Slow flickering).
1
2
Summary of Contents for Nova Power
Page 1: ...Nova Power Jump Starter...
