9
+
+
Initial installation
Batteries – Remote
control
To insert or change the batteries, press the
point marked by an embossed arrow. Push the
cover of the battery compartment down and
remove it. Insert the batteries of the alkaline
manganese type LR 03 (AAA) with the correct
polarity (+/–).
Then push the cover back on.
Note on disposal of batteries:
The original batteries do not
contain any pollutants such as
cadmium, lead and mercury.
Used batteries do not belong in
the domestic waste. They must
be taken to the appropriate
collection points according to the
national laws. Ask your dealer.
Connection
Mains
Connect the TV set to a 230V/50–60 Hertz
outlet.
Antennas
Remove the rear cover from the unit by pulling
it backwards. Clip the cables into the cable
holders and feed them downwards, through the
opening.
Insert the antenna jack protruding from above
the PIP antenna socket into the antenna socket
for the VHF/UHF tuner. Insert the antenna jack
for your antenna or cable system into the
socket for the picture-in-picture (PIP) tuner.
If your unit has one or two satellite tuners,
connect the satellite antennas to the SAT sock-
ets (see Fig., page 5).
Replace the cover.
Initial installation
Automatic programming of the TV set is started
the first time you switch it on. Follow the
menus.
First you have to select the menu language for
your set. Then you specify which antenna you
have connected to your TV and in what country
you are using it. Then you start the station
search. The TV set searches for, stores and sorts
all the stations which your antenna system
receives. You then see a list of the stored
stations in which you can mark your favorites.
Finally log in your video recorders, decoders,
Loewe audio system and Home Automation
with the connection wizard and connect these
to the TV set according to the illustrated
connection plan.
Select the settings with the
arrows on the ring ...
... confirm the settings with
OK
. You then move on to the
next menu ...
... press this button if you want
information about the settings.
You can repeat initial installation at any time,
e.g. after moving house. Call the index in the
main information (
i
button). Then select the
item ”Repeat initial installation”. Then start
”Initial installation” with
OK
.
Switching on
The display and on/off switch are accommodated
in a single unit.
Press the On/Off button so that it
snaps in.
i
OK
AV2/RGB
AV1
AV3
SAT
SAT A/D
SERVICE
AUDIO OUT
VHF/UHF
R
L
SUBWOOFER
STAND
R
SUR
DIG OUT
DIG IN
IR
1
2
SUB
L
C
RC5/RC6
AUDIO IN
VGA
CTRL
BAQ25M_31605_020_1_GB
07.07.2003, 14:36 Uhr
9
