Loewe bild 1
Quick start manual
9
english
Mounting on the table stand
For mounting the TV set on the table stand use the tool supplied (Torx
T20, Allen key SW3). The assembly steps show the device type bild
1.55. The device type bild 1.65/40/32 is assembled in the same way.
Make sure during the mounting that the TV set and table stand are
not scratched or damaged.
Follow the safety instructions when mounting in chapter
For your
safety
.
Delivery specification of the table stand:
(A) Table stand rotation unit with mounted cover (X)
(B) Table stand plate
(C) Countersunk screws M5x16 (4 items)
(D) M4x12 screws (4 items)
Step 1: Checking the rotation unit cover
Please check whether the cylindrical
cover (X) of rotation unit (A) is placed
in the correct position.
The pin (Y) and the centre hole (Z)
must be positioned as shown in the
adjacent figure. In this case, you can
proceed with the assembly.
Should this not be the case, please
pull off the cover (X) from the rotation
unit (A), and plug it into the correct
position again.
Step 2: Assembly of the rotation unit
Position the rotation unit (A) on the
table stand plate (B). The pin (Y) must
fit into the appropriate hole in the plate.
Use the four countersunk screws (C)
M5x16 to fasten the rotation unit (A)
on the table stand plate (B).
Tighten the screws with Allen key SW3
finger tight (torque approx. 5 Nm).
X
Z
Y
A
B
C
A
Y
3
;
Step 3: Positioning of the TV set
Position the TV set with the help of
another person on the table stand.
Make sure that the brackets (N1) and (N2)
are hooked into the slots on the TV.
Then apply slight pressure to click
bracket (N3) into place.
Step 4: Aligning and mounting the TV set
Fix the TV set using the four screws
(D) and M4x12 and Torx T20 wrench
(tighten only slightly).
Align the TV set with a spirit level. For
better protection against scratching
use a fleece as intermediate layer.
Then tighten the four screws (D).
Torque approx. 2 Nm (tighten hand-
tight).
Cable fixing
Using the Velcro cable tie supplied, you can fix the rear cables.
N1
N2
N3
D
Mounting on the table stand