n
Loewe SoundBox ID
- 19 -
Deutsch
English
Français
Italiano
Español
Nederlands
Dansk
Suomi
Svenska
n
- 19 -
Instructions for Use
Set-up
Connection
Set-up
•
Place the unit on an even, firm, horizontal surface.
•
Do not set up the unit near strong heat sources or in direct sunlight.
•
If setting up in a shelf or a closed cupboard: Leave at least 2.5 cm
clearance around the unit, so that the air can circulate unhindered
and there is no heat backup. Do not cover the opening at the back.
The device may not be laid on its back during operation.
• Incorrect voltages
can damage the unit. This device may only be
connected to a powersupply with the voltage and frequency indi-
cated on the type plate using the mains cable.
•
Pull out the power cable during thunderstorms. A voltage surge
caused by lightning conducted through the mains could damage
the unit.
•
If the unit is not to be used for an extended period, the plug should
also be disconnected from the mains.
•
The power plug of the unit must be easily accessible so that the
device can be disconnected from the power supply at all times.
•
Position the mains cable in such a way that it can not be damaged.
The power cable may not be kinked or laid over sharp edges, stood
on or exposed to chemicals; the latter also applies to the unit as a
whole. A power cable with damaged insulation can cause electric
shocks and poses a fire risk.
•
When you want to unplug from the mains, pull on the plug housing
rather than on the cable. The cables in the mains plug could oth-
erwise be damaged and could cause a short-circuit when plugged
in again.
Connection
Connect the
ANT FM
7
jack to an FM antenna socket via an optional
FM antenna cable (available from your dealer).
Alternatively, use the antenna provided. Position the antenna so as to
ensure the best reception, e.g. close to a window.
You can connect an external audio source to the socket
AUX
6
Use
an audio cable with 3.5 mm jack cable available from your dealer.
Plug the mains cable into a 230 V 50 Hz wall socket.
ANT FM
AUX
CLOCK
AC-IN
SET ON OFF
You can connect a headphone with a 3.5 mm jack socket to the
HEADPHONE
3
socket. The speakers of the
SoundBox ID
are then
switched off.
3.5 mm Stereo Audio
FM antenna
Mains cable