Installation instructions
Wall holder WM54
Individual 32 / 40
Safety notes
ed person.
Loewe will accept no liability for damage resulting from
improper assembly.
Install your set so that it cannot be damaged, for example, by
children playing.
Lay the connecting cables so that no-one can stumble or trip
over them.
The wall holder (and suitable adapter) are only designed for
les (mounting
rails) of the TV hung on the wall. There is a danger of
crushing.
In addition the safety instructions of our TV sets also apply
here.
Assembly
The load capacity of the wall and the fastening of the wall
holder are your responsibility.
Buy the appropriate fastening material for your wall at a
hardware store.
Consult a building expert if necessary.
Make sure there are no electric cables or pipes where you are
drilling the holes.
See the sketches 1 to 4.
Sketch 1: Scope of delivery - without Allen Wrench
Sketch 2: Preparing the TV set
Sketch 3: Connection of the TV set
Sketch 4: Wall mounting
les
must be 383mm.
TV set, remove foot, mount spacer
Pull the mains plug out of the power socket before handling the TV.
Lay a piece of felt or a soft blanket down where you want to put
down the TV set. This protects it from being damaged.
Place the TV set screen down on the prepared surface so that the
foot of the TV protrudes just over the protective underlay (felt,
blanket).
Loosen and remove the 4 screws (sketch 2, arrows C) with a scre-
wdriver.
Pull the foot off the TV in the direction of the arrow (sketch 2).
Remove the protective foils from the adhesive areas of one the two
spacers (sketch 2, arrow D).
The second spacer is not required for the ”Individual” TV set.
Stick the spacer (sketch 2, arrow D) onto the rear panel as illustra-
ted.
Connecting the plugs on the TV
The most common connections are illustrated in sketch 3.
Sketch 3
Arrow a1 = connection sockets for antenna / sat
Arrows a2 = AV 1 plug / AV 2 plug
Arrow a3 = mains connection
Fixing the cable
Stick the necessary cable clip to the TV set on the point shown in
sketch 3, arrow K. Cable Clip is not included.
Hanging in and tilting the TV set in the wall holder
Depending on the type of set, your TV can weigh up to about 40kg.
To hang in, hold the TV set tilted back about 30° (see sketch 4).
Hang the TV set into the hooks (sketch 4, arrows).
It can only be removed (unhooked from the hooks of the wall hol-
der) when the TV set is pulled away from the wall at the bottom by
about 30°.
Note
Further information such as service addresses can be found in
the operating manual of your TV set.