LOADING WATER CRAFT
PROPERLY POSITION THE
WATER CRAFT (E.G. PADDLE
BOARD, KAYAK, ETC.) ON TOP
OF THE BASE. IN MOST CASES,
THE WATER CRAFT WILL BE
UPSIDE DOWN (SUP FINS
UP AND FORWARD, SURFSKI
WITH HULL UP). SLIDE THE
ARMS INTO THE BASE UNTIL
THEY CONTACT THE WATER
CRAFT ON BOTH SIDES.
AFTER ALL 4 ARMS ARE IN
LOCKED POSITION AND TIGHT
GIVE THE BOARD A WIGGLE
TO MAKE SURE IT IS SECURE.
IF THERE IS ANY MOVEMENT,
YOU MUST ADJUST THE WATER
CRAFT TO PROPERLY ALIGN THE
ARMS WITH THE GROOVES ON
THE BASE.
UNLOADING WATER CRAFT
TO REMOVE THE WATER
CRAFT, START WITH THE KEY
POINTING DOWN LIKE IMAGE
BELOW. TURN THE KEY TO
THE RIGHT TO RELEASE THE
RATCHET AND PULL OUT
THE ARM.
WHEN NOT IN USE THE ARMS
CAN BE PLACED DOWN FOR
MORE STREAMLINE AESTHETIC.
DOWN TO THE LEFT IS LOCKED
AND WILL NOT BE ABLE TO
COME OUT, DOWN TO THE
RIGHT THE ARM IS NOT IN A
LOCKED POSITION AND CAN
EASILY COME OUT OF ITS
GROOVE. HOLE FACING LOCK
SIDE, LOCKS ARM INTO PLACE
(SEE TOP IMAGE).
ADAPTER INSTRUCTIONS
LOOSEN THE BOLT WITH A
SIZE 5MM OR 3/16” HEX KEY.
ADD THE BLACK RING ON
TOP OF THE SCREW AND
ADAPTER. ATTACH THE
ADAPTER TO THE LOAD
BAR AND TIGHTEN WITH
HEX KEY FULLY, WITH NO
MOVEMENT.
ONCE LOOSENED PULL DOWN
THE RUBBER PAD ABOVE
BELOW THE SCREW HOLE TO
REVEAL THE RECTANGLE AND
GROVE FOR THE T BOLT.
ATTACH THE ADAPTOR TO THE
LOAD BAR, WITHOUT MAKING
IT COMPLETELY TIGHT UNTIL
YOU HAVE ALIGNED THE
SCREW HOLES WITH THE BASE.
ONCE IN DESIRED LOCATION
OF THE LOAD BAR, TIGHTEN
COMPLETELY, WITH NO
MOVEMENT AND PROCEED TO
TIGHTENING OF THE BOLTS ON
THE LOAD BAR. CAREFUL NOT
TO OVER TIGHTEN AND STRIP.
