INSTRUCTION MANUAL
Move the iQ 16 Cart to where you intend to store and secure it.
Note: It is best if the Floor Plate is as close as possible to a wall to reduce the hazard or tripping
and injury.
Attach the end of the chain to the steel loop with the padlock and position the plate end in the desired
position on the floor.
Note: If mounting on carpet, you will need to cut out the carpet from the area where the floor plate
attaches, otherwise the carpet will wrap around the drill when drilling.
Mark the centre of each of the
3 holes using the floor plate as
a guide.
Drill a 10mm hole through each
of the 3 marked centres to a
depth of 50mm.
Insert the anchor bolts with the nuts attached into the
holes through the floor plate. Using the 13mm spanner,
progressively tighten down each of these anchor nuts so
that all three bolts are firmly anchored into the concrete.
Now undo each of the three nuts and in their place
thread on the three silver shear-nuts. Ensure that the
‘cone’ is down and the hexagonal nut is up. Using the
17mm spanner, tighten down the three shear-nuts until
the hexagonal ‘head’ shears off, leaving just the cone
‘base’.
Attach the security chain through the
steel loop under the side of the trolley
using the padlock.
Note: there is a lock-down loop on
both sides of the iQ 16 Cart.