USING THE POWER STRIP WITH THE REMOTE
USING THE POWER STRIP
REMOTE
Setting the programmed timer duration in ECO-TIMER-ALL or ECO-TIMER-CYCLE modes:
1.
Pressing the SAFE-ON button on the remote control will turn ON all the outlets sequentially and will remain on until
any other mode is set.
2.
Pressing the 1HR-ALL or 3HR-ALL buttons on the remote control will activate ECO-TIMER_ALL mode.
a)
All the outlets will turn on sequentially and will turn off automatically after one or three hours has elapsed
respectively.
b)
The MODE indicator will flash the number of times corresponding to the specific button pressed to reflect the
timer duration. Ie pressing the 3HR-ALL button will result in three flashes, corresponding to a 3-hour timer
duration.
3.
Pressing the 1HR CYCLE or 3HR CYCLE buttons on the remote control will activate ECO-TIMER-CYCLE mode. This
function cycles each outlet on the power strip, giving it a set amount of charge time.
a)
The time duration is determined by the specific CYCLE button pressed. Ie 1HR-CYCLE button corresponds to 1-
hour timer duration,
b)
When the timer duration has elapsed the outlet will be turned OFF and the next consecutive outlet will turn ON
automatically.
c)
The MODE indicator will flash the number of times corresponding to the specific CYCLE button pressed to reflect
the timer duration. Ie pressing the 3HR-CYCLE button will result in three flashes, corresponding to a 3-hour timer
duration.
4.
Pressing the SAFE-OFF button on the remote control will put the power strip into SAFE-OFF mode cancelling any other
mode.
Setting the operating mode without the remote control:
1.
Pressing the MODE button consecutively will cycle the power strip through its different operating modes in this
sequence; SAFE-ON to ECO-TIMER-ALL to ECO-TIMER-CYCLE to SAFE-OFF and repeating from the start.
2.
The MODE indicator will indicate the operating mode of power strip;
a)
In SAFE-ON mode the MODE indicator will be on continuously.
b)
In ECO-TIMER-ALL mode, each outlet will turn on sequentially and the MODE indicator will flash the number of
times corresponding to the programmed timer duration. Eg Three flashes indicates a 3-hour setting.
c)
In ECO-TIMER-CYCLE mode, only one outlet will turn on and the MODE indicator will flash the number of times
corresponding to the programmed timer duration. Eg One flash indicates a 1-hour setting.
d)
In SAFE-OFF mode, the MODE indicator will be OFF.
1.
When the power strip is in ECO-TIMER-ALL mode, pressing and holding the MODE button on the power strip for 3-
seconds will allow the programmed timer duration to be changed.
2.
After 3-seconds have elapsed the MODE indicator will flash quickly.
3.
Continuing to hold the MODE button down will cycle the programmed timer duration through this sequence, pausing
for 3-seconds between each outlet;
o
1-hour (outlet #1 indicator will illuminate),
o
2-hours (outlet #2 indicator will illuminate),
o
3-hours (outlet #3 indicator will illuminate),
o
4-hours (outlet #4 indicator will illuminate), and repeat from the start.
4.
Release the MODE button on the desired Time setting. Eg If you want the ECO-TIMER-ALL to charge for 2 hours,
release the MODE button when Outlet #2 is illuminated.
5.
The MODE indicator will flash the number of times corresponding to the number of hours programmed. Eg Two
flashes indicate a two hour setting.
6.
The programmed timer duration will survive any loss of power.
WITHOUT
NOTE: The outlet indicator will show the outlet that is ON;
o
If the outlet is powered OFF the outlet indicator will be OFF.
o
If the outlet is powered ON, the outlet indicator will be ON.
