4.1
Insert the square shaft through the exterior panel. Cut the shaft according to the
door thickness. Then install the exterior panel, shaft, EVA and the escutcheon in place.
4.2
Route both the lockset and exterior panel cables through the corresponding holes
then insert the positioning sleeve into the inner side of the square shaft. Make sure
they are all aligned and correctly oriented.
4.3
Check both inner and outer handles if they are in smooth operation. Then check if
the locking and unlocking operations are smooth. If not, adjust the mounting screws
until the the operation is running smooth. See illustration as shown below:
Shaft Installation
Inside Door: The shaft
must be inserted in place
after installation. The
shaft must pass through
completely the lock
body, as shown below.
Outside Door: After the shaft
is installed, pull the shaft
outward by hand in the
direction of the arrow, and
ensure the shaft cannot be
pulled out.
