2
. Draw-bar
2. Pin
3. Axle with hole
4. Elastic pin 5. Fork frame
(Fig. 1)
When attaching the handle, you had better squat just behind the pallet truck. Then you:
2.1.
Insert the draw-bar onto the pump piston (A)
,
then use a hammer to insert the axle with
hole(K) into the hydraulic pump and draw-bar
from the right to left.
(See fig. 2 ).
2.2.
Let control handle to the ‘
LOWER
’ position, then pass
the adjusting nut (G), adjusting bolt (F) and chain (E)
through the hole of axle(K) with your hand (See fig. 3)
2.3.
Press the draw-bar (D) down, take away the pin(#2) (See Fig. 1).
2.4.
Let the control handle on ‘
RAISE
’ position, then raise the lever plate (J) with the pin (#2)
and insert the adjusting bolt(F) into the front slot of lever plate, note to keep the adjusting
nut (G) on the under side of the lever plate(J).
2.5
Use a hammer to tap another elastic pin into the axle with hole (K). The Draw-bar is now
assembled to the pump.
Fig.2
Fig.3
