3
loadstarsensors.com
User Guide
Connect Sensor to Interface
§
Connect a 4-wire load cell as shown in wiring diagram above. Slots 5 and 8 (nor marked) are to
be used for calibration only and are not used during normal operation. Connect only the shield
to slot 8. If you want to connect the voltage output into your own DAQ then you can tap into the
output signal between pins 5 and 8.
§
If your unit has been shipped with a calibrated load cell, simply plug the provided terminal in to
the 8-pin terminal receptacle.
§
Connect the included power supply as shown.
§
Connect the included USB cable to the PC as shown.
