30
•
Job
— The job selected for the selected recipe.
•
Width
— The measurement width.
•
Length
— The measurement length.
•
X resolution
— The X resolution length.
•
Y resolution
— The Y resolution length.
•
LED Pulse
— LED pulse width.
•
FIR Length
— FIR length in use.
•
Detection Filter
— Detection filter in use.
•
Peak Threshold
— Peak threshold in use.
•
Average Intensity Filter
— Average intensity filter in use.
•
Measuring
— Settings related to the measurement process.
•
Lines
— The number of measurement lines.
•
Points
— The number of measurement points.
•
Scanning time
— The time it took to scan the image.
•
3D view
— The XYZ work area of the measurement table.
•
Z-Range Histogram
— The height distribution of the current work, which helps to see if height adjustment is
needed.
•
Intensity Histogram
— The intensity distribution of the current work, which helps to see if intensity adjustment
is needed.
Typically, an intensity level of 100-150 is recommended, as it is high enough to produce good picture quality,
and low enough not to cause saturation.
2.2.6 Analysis
On the
Analysis
tab, you can define analysis-related parameters. The
Analysis
tab is depicted in the figure below:
The settings on the
Analysis
tab are:
•
Results
— Buttons related to the scanning results.
•
Open
— Open the file selected in the result file list.
•
Substitute
— Replace the currently opened results with the selected result file.
•
Calendar
— Open a calendar view, to open result files from the selected day.
See also
Figure 28 Analysis Tab