LM-ProPower CombiLED Installation
1. Consult a qualified technician to install to air and, if applicable, to water supply.
2. Connect the foot control cable to the foot control and to the rear side of the unit.
3. Connect the power cord to the unit and the AC power outlet.
4. Fill the medicament bottle with water or medicament solution, screw the bottle connector onto the bottle and push it onto the
connector on the left side.
5. a. Unscrew the powder container from the cap and fill with LM-ProPower polisher powder up to MAX. Screw the container
back to the cap.
5. b. Connect the powder container to the connectors on the right side of the unit.
6. a. Gently slide a LM-ErgoGrip onto the polisher handpiece. Screw the nozzle clockwise into the polisher handpiece until the
nozzle is firmly tightened up.
6. b. Gently slide a LM-ErgoGrip onto the scaler handpiece. Place the tip in the torque wrench and use the torque wrench to
screw the tip clockwise onto the scaler handpiece. Tighten until resistance and the torque wrench slides.
See the
operational
instructions
in the manual.
NOTE! Before installing and using the device please read the manual.
0517_9770113F
6.b.
1.
2.
3.
4.
5a.
5b.
6a.
6b.
7.
LM-Instruments Oy
Norrbyn rantatie 8
FI-21600 Parainen
Finland
+358 2 4546 400
[email protected]
www.lm-dental.com
LM
Dental