6
www.lloytronhelpdesk.com
1.
On each chime unit, press and
hold the chime selection button
or chime replay button for 10
seconds. An audible beep beep will
be heard. The chime unit is now in a
waiting mode for 15 seconds to link
the transmitter.
LINK / PROGRAMME DEVICES
You will be required to link/programme this new accessory to your existing MIP System™. It is advisable to link
before you mount the Motion Sensor Module.
Note:
for easy programming, keep the Motion Sensor Transmitter and chime unit close together whilst linking/
programming. This saves time and effort.
2.
Using the switch at the rear of
the unit after the batteries has been
installed. Move the switch to the
ON position and an audible BEEP
will be heard again to advise the
Sensor transmitter has been linked
successfully.
If multiple receivers are being used, then each receiver must be programmed to the corresponding bell push
individually.
Also refer to individual device manual for accessories before linking.
BEEP
BEEP
BEEP
4.
SWITCH the Sensor OFF and
then back ON to trigger the Chime
Unit sound.
BEEP
BEEP
3.
To exit programming mode, press
the chime replay button again or
wait several seconds until a beep
beep is heard. The link process has
now completed.
