31
Maintenance
Precautions
Verify that the alarm can be armed and disarmed normally.
Verify that the alarm can call the numbers when activated.
Verify that the alarm can receive the signal from the sensors and that the backup battery is working
normally.
Activate the sensor by passing your hand in front of it to verify that it sends the signal to the alarm
normally.
Check the battery level.
Activate the sensor by separating the units to verify that it sends the signal to the alarm normally.
Check the battery level.
Do not disassemble, repair or change the parts of the product on your own, it could cause failures or
accidents.
Do not throw the product on the floor to avoid failure or damage from impact.
The system needs periodic inspections to ensure its stability and good performance. We suggest that an
inspection of the alarm is made every three months and every month for the detectors.
Main panel
Motion sensor
Magnetic sensor
1.
2.
3.
1.
2.
1.
2.
1.
2.
Command table for call setup
The alarm can also be set up through calls or SMS messages using the GSM system included.
To set up the alarm through call, follow the steps below:
Call the alarm’s SIM card number.
Enter [pa [#] to enter the setup mode.
Enter [c[par [#].
1.
2.
3.
Description
Command
Example
Parameter
Set up emergency call
phone numbers
Delete emergency call
phone numbers
Set up phone numbers for
emergency SMS
Delete phone numbers for
emergency SMS
Turn the voice assistant
on or off
3
3
3
3
11
Number Position in List
(1-6)] +
[Phone Number]
Number Position in List
(7-9)] +
[Phone Number].
Phone number position
in list to be deleted
(7-9)].
1 to turn on / 0 to turn
off].
Phone number position
in list to be deleted
(1-6)]
315548693578#
31#
375548693578#
37#
110#