Setting up your Blood Pressure Monitor
Voice output
Dat
e/T
ime
• Insert the batteries or press and hold the Memory button for 5 seconds.
The year flashes on the display.
The device is ready for use.
You may start measuring.
• Set the year with the function buttons
and confirm with the Memory button .
• Set the month, day, hour and minutes and confirm each setting with the Memory button
.
Language
The language will flash on the display .
• You can select the following languages with the function buttons
:
= English
= Language off
English
Confirm your selection with the Memory button .
= Language off means that there is no voice output and therefore no acoustic
playback.
Volume
Volume level Vo1 flashes on the display.
• You can set the volume of the selected language using the function buttons
:
Vo3 = loud
Vo2 = medium
Vo1 = quiet
Confirm your selection with the Memory button .
How to use your Blood Pressure Monitor
If the measurement is performed on the right upper arm, the line should be located on the inside of your elbow.
Ensure that your arm is not pressing on the line.
Fit the cuff on your arm.
Blood circulation in the arm
should not be restricted by tight
clothing or other objects.
The cuff should be placed on the upper
arm so that the lower edge is about 2 to 3
cm from the bend of the elbow and above
the artery. The tube should be in line with
the centre of the palm.
Tighten the free end of the cuff,
but make sure that it is not too
tight around the arm and close
to the hook-and-loop fastener.
The cuff should be fastened
so that two fingers fit under
the cuff.
• Please ensure the unit is at room temperature before measuring.
Insert the cuff line into the
connection for the cuff connector.
Positioning the cuff
1.
3.
2.
4.
10
11
