User manual
3
How to insert the batteries:
Open r
emote
s
ensor
battery compartment cover
,
i
nsert 2 x AA batteries
respecting
polarity
Open battery compartment cover of weather station.
Insert 2 x AA batteries respecting polarity, all the icon on the LCD display will light up for 3
seconds, and you will hear a beep tone, and detect indoor temperature & humidity.
The weather station will start to make a connection to the remote sensor. This operation takes
about 3 minutes and is displayed by a flashing reception RF antenna symbol in the “remote
sensor” display area on the receiver.
After receiver has created a connection to the remote sensor, it will enters the radio control
time receive mode.
Low battery:
If the battery symbol “
” appears the batteries in the remote sensor should be replaced as soon
as possible.
Reception of the Radio signal:
The clock automatically starts the DCF signal search after 7 minutes of any restart or changing
of new fresh batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00 am, the clock automatically carries out the synchronization procedure with
the DCF signal to correct any deviations to the exact time.
If this synchronization attempt is unsuccessful (the radio mast icon disappears from the
display), the system will automatically attempt another synchronization at the next full one hour.
This procedure is repeated automatically up to total 5 times.
To start manual DCF signal reception, press and hold down the “
▲
” button for two seconds. If
no signals received within 7 minutes, then the DCF signal search stops (the radio mast icon
disappears) and start again at the next full one hour.
During RC reception to stop searching radio signal, press the “
▲
” button once.
F.Y.I.:
A flashing radio mast icon indicates that the DCF signal reception has started
A continuously displayed radio mast icon indicates that the DCF signal was received
successfully
We recommend a minimum distance of 2.5 meters to all sources of interference, such as
televisions or computer monitors
Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such
extreme circumstances, place the system close to the window.
During the RC receive mode, only the "
▲
" button function, other button operation have no
function, If you want to carry out other functions of operation, please press "
▲
" button to exit
the RC receiving mode.
