Instruction Manual
5
2.
Place the feed screw into the
head, long end first, by
turning the feed screw slightly
until it is set into the motor
housing (fig.3).
3.
Place the cutting blade onto
the feed screw shaft with the
blade facing the front as
illustrated (fig.4). If it is not
fitted properly, meat will not
be ground.
MINCING MEAT
1.
Cut
all
foods
into
pieces
(Sinewless, boneless and fatless
meat are recommended), in
approximate size:
20 x 20mm so that they fit easily
into the hopper opening.
2.
Plug in and press “ON” switch
button.
3.
Feed foods into hopper plate
hole. Use only the food pusher
(fig.7).
4.
After use, switch the unit off and
unplug it from the power supply.
4.
Place the desired cutting plate
next to the cutting blade, fitting
protrusions in the slots (fig.5).
5.
Support or press the center of
the cutting plate with one finger
then screw the fixing ring until
tight with another hand (fig.6).
Do not over tighten.
7.
Place the hopper plate on the head and fix into position.
8.
Locate the unit on a firm place.
9.
The air passage at the bottom and the side of the motor housing should be kept free and not
blocked.
