Instruction Manual
12
Open the carton box and take out the fan (fig. 1).
Assemble the support plate on the ceiling using two or more screw anchors and appropriate washers.
Attention: the provided screw are for wood joist and concrete ceiling. (Fig. 2).
Insert the support rod through the upper cap and lower cap.
Insert the electric cables coming out from the motor through the support rod and connect them to the screw
terminal placed on the top of support rod.
Fix the support rod to the motor using the pin and pin’s nut. (Fig. 3)
Hang the fan on the hook on the support plate and connect the electrical cable coming from the ceiling to
the screw terminal placed on the top of support rod, make sure the receiver must be insert into support
plate (see Remote control connection).
Slide upwards the upper cap and fix it with the screw. (Fig. 4)
Slide downwards the lower cap; it must be supported by the motor. Fix it with the screw. (Fig. 4)
Center the slots on the blades with the heads of the blades fixing screws and slide the blades so that the
head of the screws are positioned at the end of slot. (Fig. 5)
Tighten the screw. (Fig. 6)
Remove the screws from connect plate of the motor, please organize all the wires carefully into connect
plate.
Assemble and align the holes on the back of LED light to the three screws on the connect plate of motor.
(Fig. 7)
Then tighten the three screws on the LED plate, connect the connector together with the motor wire, please
make sure the light kit can't be moved after tighten the screws. (Fig. 8)
Place the lamp shade on the fan (fig. 9)
