Instruction manual
8
OUTSIDE SURFACE
Use mild detergent or baking soda and hot water solution. Non-abrasive scouring powder can be used on
stubborn stains, then rinse with water.
If the inside surface of the barbecue lid has the appearance of peeling paint, baked on grease build up has
turned to carbon and is flaking off. Clean thoroughly with strong hot soapy water solution. Rinse with
water and allow to completely dry.
Never use oven cleaner.
INTERIOR OF BARBECUE BOTTOM
Remove residue using brush, scraper and/or cleaning pad then wash with a soapy water solution. Rinse
with water and allow dry it.
PLASTIC SURFACES
Wash with a soft cloth and hot soapy water solution. Rinse with water. Do not use abrasive cleaners,
degreasers or a concentrated barbecue cleaner on plastic parts.
COOKING PLATE
Use a mild soapy water solution. Non-abrasive scouring powder can be used on stubborn stains then rinse
with water.
GREASE TRAY
Please do not open the grease tray during use.
Please check the grease drain off and take away the oil when 1/3 full.
CLEANING THE BURNER ASSEMBLY
Turn the gas OFF at the control knob and disconnect the cylinder.
Remove cooling grate.
Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall
the burner, check to ensure that the Gas valve orifices are correctly positioned and secured inside the
burner inlet (venturi).
In some cases your barbecue will light back because of an insect crawling inside the burner venturi or a
spider spinning its web inside the burner. This can be rectified by using a bottle brush inserted through the
burner venturi and pushing it into the burner over the burner length. If condition persists consult your gas
dealer.
SERVICING
Your gas barbecue should be serviced annually by a competent registered person.
