LIVOLTEK BLF51 Series, Operating Manual

Page: 10 / 20

7
5. Mounting
5.1 Requirements for Mounting
Check to make sure the installation site does not fall into any of the
following conditions: If any do, then a risk assessment will be required.
•
This product is designed only for indoor use.
•
Unsafe due to assessment of occupational health safety risks.
•
The ambient temperature is outside the range of tolerable ambient
temperature (-20°C to +50°C, -4°F to +122°F).
•
Close to flammable materials or areas where flammable materials are
stored.
•
Prone to be damaged by sea water.
•
Prone to be flooded or high levels of snow falls.
•
Close to corrosive gas or liquid (for example, locations where
chemicals are processed or stored).
•
Exposed to direct sunlight or in an enclosure exposed to direct sunlight.
•
Little or no air flow
•
Mounted on a surface without suitable fire/heat rating.
•
Mounted on a wall without suitable load holding capacity.
•
High humidity.
•
Sites considered unsafe because of local regulations.
•
Confined space without adequate airflow.
•
Area subject to sand or dust storms.
•
Exposed to steam, vapor, or water.