5
PA10 • Fig. 4a
General Assembly Instructions
1. Unpack the aeration system to ensure all parts were received. If a shortage
occurs, please notify EasyPro immediately.
2. Assemble diffusers, detailed instructions included with each diffuser
assembly.
NOTE:
Video walk-through of EPMD1/EPMD2 diffuser assembly and installation
found at: easypropondproducts.com/diffuser-assembly
3. For Sentinel Deluxe units, the filter and valves are connected to the com-
pressor.
For basic kits you will need to install the inlet filter and outlet assembly.
On all basic kits, remove the compressor from the box and remove plugs
from ports on the compressor. Then assemble air filter on the inlet port and
valved outlet assembly on the discharge port. PA10 and PA12 systems are a
single line with no valve.
See images for reference of your system.
4a. For
PA10
style kits (1/20 hp DC22 Compressor)
4b. For
PA12
style kits (1/8 hp DC12 Compressor)
4c. For
PA50/75/100
style kits (1/4, 3/4 and 1 hp Rotary Vane Compressors)
5. Unroll the entire roll of tubing. It is recommended that the diffuser be in-
stalled at this point. This will allow you to trim any unused tubing before at
-
taching to the compressor. Use clamps to secure tubing to outlet assembly.
6. Open the valves on the outlet assembly to their full open position. Plug the
compressor into a GFCI outlet and adjust each valve to equal the air flow to
each diffuser. This equalizes air flow between diffusers with different operat-
ing depths and/or tubing lengths.
PA12 • Fig. 4b
PA50 • Fig. 4c
PA75 • Fig. 4c
PA100 • Fig. 4c
Summary of Contents for AirPro PA10
Page 1: ......
