00500
SAFETY WARNING
Our Bunk Beds have been tested by an Independent Laboratory and are certified to be in compliance with: ASTM F-1427,
“Standard Consumer Safety Specification for Bunk Beds” and U.S. Government specifications 16 Code of Federal
Regulations, parts 1213 and 1513.
SAFETY WARNINGS
1.
Follow the information on the warnings attached to the upper bunk end structure and on the carton. Do
not remove this
label.
2.
Always use the recommended size mattress or mattress support, or both, to help prevent the
likelihood of entrapment or
falls.
3.
Surface of mattress must be at least five inches(127mm) below the upper edge of guardrails.
4.
Do not allow children less than six years of age to use the upper bunk.
5.
Periodically, check and ensure that the guardrail, ladder and other components are in their proper
position, free from
damage and that all connectors are tight.
6.
Do not allow horseplay on or under the bed and prohibit jumping on the bed.
7.
Prohibit more than one person on upper bunk.
8.
Always use the ladder
or bed end
for entering and leaving the upper bunk.
9.
Do not use substitute parts. Contact manufacturer or dealer for replacement parts.
10.
Use of a night-light may provide added safety precautions for a child using the upper bunk.
11.
If the bunk bed will be placed next to a wall, the guardrail that runs the full length of the bed should be
placed against
the wall to prevent entrapment between the bed and the wall. (This applies only to bunk
beds without two full-length
guardrails.)
12.
Always use guardrails on both long sides of the upper bunk.
13.
The use of water or sleep flotation mattress is prohibited.
14.
Keep these instructions for future reference.
STRANGULATION HAZARD
15.
Never attach or hang items to any part of the bunk bed that are not designed for use with the bed for
example, but not
limited to hooks, belts and jump ropes.
SIZE OF MATTRESS AND FOUNDATION
Your Twin bed is designed to use a mattress 3
7
”-3
9
” in width and 74” - 75” in length.
Your Full bed is designed to use a mattress 52”- 54” in width and 74” - 75” in length.
The total thickness of mattress and foundation (slat kit, bunk board, etc.) combined must not exceed
10
”.
Note: There must be at least 5” from mattress sleeping surface to top edge of guardrail.
A FOUNDATION IS REQUIRED WITH 3 SLAT CONFIGURATION
