Living & Co TWFP10000 Operating Instructions Manual Download Page 8

Your Living & Co product has been inspected and tested and is guaranteed subject
to the following for a period of one year from the date of purchase against defects
in workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Living & Co product fails to operate satisfactorily, please return it to the
retailer from whom it was purchased. To obtain a repair or replacement product
under this warranty, you will need to produce satisfactory evidence of date of
purchase. The completed warranty and purchase receipt must be presented with
the product. The warranty should be filled out at the time of purchase. It is in your
interest to make sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be
of the same or similar product or accessory excluding packaging, instruction card
etc. Where a replacement product is supplied, this shall be guaranteed for the
balance of the original warranty period.
Any model that is no longer available will be replaced by a model of a value and
with such features as we consider appropriate in the circumstances. Living & Co
Ltd is not responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers Guarantee Act (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation,
then that provision shall be deemed to be excluded from the warranty and the rest
of the provisions will continue to apply.

ONE 

YEAR 

W

ARRANT

Y

IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD

NAME:

ADDRESS: 

PURCHASED FROM:

SUBURB:

DATE OF PURCHASE:

NAME OF PRODUCT:

MODEL No:

Summary of Contents for TWFP10000









Reviews: