Page 8 of 24
Toll Free: 800-749-5783
www.platinumtools.com
6. Ignore Button
- Press to ignore events that are part of the
circuit’s normal operation.
7. Test Button
- Press Button to start a monitoring session. Press
during a monitoring session to stop a test if running.
8. Distance/Units Button
- Press and hold the Display and Ignore
buttons for 3 seconds. The “ft” or “m” icons will flash denoting
the new unit used for measurement.
9. Terminal Block Connectors
- Insert the circuit wires or jumpers
into these blocks and insert the blocks into the designated jacks.
To remove the Terminal Block Connectors:
a.) push and hold the orange side tabs towards the jack
b.) then pull the block connector out.
Tel: (855) 346-3358
livewireinnovation.com
