8 GB/IE/NI
Note:
Charge the product for approximately
12 hours before first use.
Note:
Charge the product at least once a month,
if it is to remain unused for an extended period of
time.
Note:
If the product has not been charged for an
extended period of time (approx. 2 months), you
could find that the integral rechargeable batteries
have entered a dormant state. Charge and dis-
charge the product a number of times in succession
to reactivate the integral rechargeable batteries.
Switch off the product during the charging
process.
Insert the power output connection plug of the
mains adapter
3
or the car adapter
4
into
the power input connection socket
6
in product.
Note:
During charging from a cigarette lighter
socket, ensure that the plug is always com-
pletely inserted into the cigarette lighter socket
of the vehicle. Failure to observe this advice
may result in risk of fire from overheating.
Insert the mains adapter
3
into a mains
socket or the car adapter
4
into the cigarette
lighter socket of your vehicle.
Note:
The product has an overcharging pro-
tection system. Nevertheless, you should dis-
connect the product from the mains once the
charging process is complete.
Note:
The indicator LED
2
illuminates red
during the charging process. When the charg-
ing process is complete, the indicator LED
2
illuminates green. When the indicator LED
2
illuminates green, pull the mains adapter
3
out of the mains socket or the car adapter
4
out of the cigarette lighter socket. Disconnect
the adapter from the product to prevent the
batteries from discharging themselves.
Use
Mounting the Product
The magnet holders
8
at both end of the
product and the lamp pole
9
are rotatable
(see Fig. A).
Rotate the magnet holders
8
to ensure that
the product can be secured in place by using
the hooks
1
, or magnets
7
on a flat and
ferromagnetic surface e.g. engine cowling
(see Fig. B).
CAUTION!
Please pay attention to the hands’
position during rotation of the magnet holders
to avoid squeezing your fingers (see Fig. C)
After the product is secured in place, rotate the
lamp pole
9
to adjust the lighting angle at the
desired position.
Using the product disconnected
from a power supply
Fully charge the product, as described in the
section on “Charging the product”.
Press ON / OFF switch
5
once: 18 LEDs are
switched on.
Press ON / OFF switch
5
twice: 36 LEDs are
switched on.
Press ON / OFF switch
5
thrice: The device is
switched off.
Troubleshooting
Fault
Possible causes and cures
No functions - Mains adapter
3
or car
adapter
4
is not fully inserted.
- check the mainpower socket can
be functioned properly
- check the house’s fuses
Indicator LED
2
does not
illuminate
When connected to a
cigarette lighter socket:
- Is the cigarette lighter socket
supplied with power? Some
cigarette lighter sockets only
supply power with the ignition
switched on.
- Check the fuse in the vehicle.