9
GB
the charging process is not influenced by
the light being switched on.
Insert the solar cable plug
14
into the solar
electricity socket
8
of the spotlight
10
.
Position the solar cell
12
as described in
section “Mounting the solar cell
12
”.
Note:
With steady exposure to sunlight,
the rechargeable battery is fully charged
after 4 to 6 days. The duration of the charg-
ing process depends on the charge state of
the rechargeable battery as well as the
quality of the exposure to sunlight.
Assembly
Note:
Remove all packaging materials from the
product.
Before mounting, decide where you want to
Mount the solar cell
12
and the spotlight
10
.
The solar cell
12
and the spotlight
10
can be
mounted independently of each other, but after
being mounted must be connected with the ap-
prox. 5 m long power cable of the solar cell
12
.
After the mounting, lay the cable so it is not sub-
ject to any mechanical stresses. Use typical in-
stallation material such as cable clamps or
conduit to fasten the cable, to prevent damage
to the insulation.
Note:
The included mounting material is suitable
for ordinary solid concrete or masonry construc-
tion. Other wall substrates may require other
fastening materials. Seek specialist advice if
necessary.
Mounting the spotlight
Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power
drill to drill the holes into the brick wall. Always
observe all safety instructions for the power drill
in the manual for the power drill. Death or injury
due to electric shock may otherwise result.
When selecting the mounting location for the
spotlight
10
, pay attention to the following:
Make sure the spotlight
10
illuminates the
desired area. You can move the spotlight
10
.
Make sure the motion detector
9
covers
the desired area. The motion detector
9
has a maximum coverage range of 12 m,
with a coverage angle of about 180°
(depending on the mounting height – a
height of 1.8–2.5 m is ideal) (see Fig. D).
Make sure the motion detector
9
is not
illuminated at night by street lighting. This
can influence its functioning.
Unscrew hinge joint
4
to detach the
mounting bracket
3
from the spotlight
10
.
Utilize the mounting bracket
3
as a template
for making the position of the two outer drill
holes.
Then drill these holes and attach the mount-
ing bracket
3
using the supplied dowels
1
and screws
2
.
Now attach the spotlight
10
to the mounting
bracket
3
using the previously removed
hinge joint
4
, spring washer
5
and flat
washer
6
. Please make sure that the
spring washer
5
and flat washer
6
are
located as fig A.
Mounting the solar cell
Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power
drill to drill the holes into the brick wall. Always
observe all safety instructions for the power drill
