8 GB/IE/NI
Safety / Preparation / Installation
To prevent burns, ensure that the light is switched
off and has cooled down before touching it.
Lamps become very hot.
Do not attach the light to a damp or conductive
substrate.
Do not look directly into the light source (light
bulb, LED etc.).
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
Do not use optical instruments to look at the
illuminant.
Safe working
The outdoor light is splash-proof.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having diffi-
culty concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
– Pencil / marking tool
– Voltage tester
– Cross-tip screwdriver
– Electric drill
– Edge cutter
– Drill (ø 6 mm)
Prior to installation
Important:
Ensure that a qualified electrician, or
a person trained to carry out electrical installations,
performs the electrical installation.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (Position 0).
Use the voltage tester to verify the de-ener-
gised status.
Installation
Remove the light cover
1
.
Unscrew the lamp housing
2
from the wall
bracket
4
by loosening the screws
9
coun-
terclockwise.
Note:
Make sure not to lose the silicone rings
10
.
Remove the wall bracket
4
from the lamp
housing
2
.
Use the holes of the wall bracket
4
intended
for the screws
11
to mark the drill holes.
Make sure that the drill holes are exactly
aligned.
Now drill the fixing holes (Ø 6 mm, depth
approx. 40 mm).
Be careful not to damage the supply line.
Insert the wall plugs
3
into the drill holes.
Open the membranes
12
for the cable bushing
in the wall bracket
4
with a sharp object (e.g.
screwdriver).
Feed the mains connection cord (external)
5
through the opened membranes
12
.
Secure the wall bracket with the included
screws
11
, washers
14
and silicone rings
10
.
Make sure that the cable bushing is positioned
underneath the fastening screws.
Open the junction box
7
.
Feed the mains connection cord (external)
5
through the protective tube
6
.
Connect the mains connection cord (external)
5
using the lustre terminal
8
.
Be sure the colours of the connected lines
match (L or 2 = black or brown, N or 1 = blue
or white).
Installation / Cleaning / Disposal / Warranty and service
Summary of Contents for 302835
Page 3: ...A 1 1 2 2...
