LIVARNO LUX 284923, Assembly, Operating And Safety Instructions

Page: 14 / 49

14 GB/IE
Disposal / Warranty and Service
Safe working
Position the lamp so it is protected from moisture
and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Do not cover the lamp with objects. Excessive
heat can result in fire.
Do not look into the LED from a close distance
during operation.
Do not look into the LED with an optical instrument
(e.g. magnifier).
In order to disconnect the light completely from
the power supply, the mains plug or power
supply must be removed from the socket.
The fixed LED module is not replaceable. If the
LED module is damaged, please dispose of the
light.
Start-up
Assembly
14100602L:
Carefully pull the cable
4
out through the
lamp base
3
.
Push the tube
6
through the lamp base
3
.
Place the washer
7
, toothed washer
10
and
the nut
8
over the thread and tighten with the
tool
14
.
Attach the reflector
1
to the tube
6
.
Turn the reflector
1
into the desired direction.
14121402L:
Place the tube
6
onto the lamp base
3
and screw it from below using the supplied
screws
13
.
Switching the light on / off
14100602L:
Plug the power supply
5
into a properly
installed socket.
Switch the lamp on or off using the ON / OFF
switch
2
.
14121402L:
Plug the mains plug
9
into a properly installed
socket.
Switch the lamp on or off using the ON / OFF
switch
2
.
Adjusting the reflector
or spotlight
Note: Only change the position of the reflector
1
if the lamp is turned off.
Allow the light to cool off completely.
14121402L:
Adjust the reflector
1
to the desired position.
Tighten the locating screw
12
using the Allen
key
11
.
Hold the locating screw
12
from the other side
using the second Allen key
11
while you retigh-
ten the locating screw
12
.
14100602L:
Turn the reflector
1
to the desired position.
Angle the reflector
1
to your liking.
Maintenance and Cleaning
Note: The device is maintenance-free.
The LEDs are not replaceable.
RISK OF ELECTRIC SHOCK!
Unplug the mains supply or the mains plug from
the socket.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the lamp to cool down
completely.
RISK OF ELECTRIC SHOCK!
For electrical safety, never clean the light with
water or other liquids, or immerse it in water.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
Unplug the mains supply
9
or the mains
plug
5
from the socket.
Only use a dry, lint-free cloth for cleaning.
Safety / Start-up / Maintenance and Cleaning