10 GB/IE/NI
ble by turning the nut of the
cable gland.
Connect it with the connection
terminals in the connection box.
Pay attention to the markings
on the terminals
11
(L for live,
N for neutral and for the
earth wire) (Fig. C).
Close the connection box.
Align the spot into the desired
direction. For this, you may need
to slacken the screw of the hinge
joint
5
. After alignment, tighten
the screw of the hinge joint
again, to ensure a secure hold.
Reinsert the fuse or switch the circuit
breaker back on. Your light is now
ready to use.
Start-up
Adjusting the
motion detector
Depending on the preadjustments
of the motion detector
7
, the spot
1
will switch itself on for a certain
period of time as soon as the motion
detector detects movement. These
preadjustments are made using the
three controllers on the underside
of the motion detector (Fig. B).
Setting the lighting
duration
Turn the rotary control TIME
9
clockwise to increase the dura-
tion of the illumination. The
lighting duration can be adjusted
within a time window of approx.
10 seconds to 4 minutes.
Adjusting the sensi-
tivity of the sensor
Turn the rotary control SENS
8
clockwise to increase the
sensitivity of the sensor.
Note:
The motion detector
responds to heat radiation. When
outdoor temperatures are low,
it is more sensitive to body heat
than when outdoor temperatures
are warm. Be sure to regulate
the sensitivity of the sensor
over the course of the year.
Summary of Contents for 279890
Page 3: ...A B 5 6 7 2 4 10 9 8 3 1 ...
Page 4: ...2 5 m C D 11 ...
