25
GB/IE
You may repeated press the
or
to adjust the ligh-
ting area of the connected
LED strips (max. 10m).
After setting the lighting area,
press
w/cw
button and then
press the
or
to adjust
the luminosity.
Shortening the LED
strip (see Fig. C)
The LED strip
2
may be trimmed
to size. It can be cut with scissors
at the marked position, as shown
in Fig. C. The trimmed sections
can then be connected as shown
in figure C.
DANGER TO
LIFE BY ELECTRIC SHOCK!
Before performing any work, first
disconnect the product from the
mains power. Unplug the power
supply
3
from the socket.
Connect as described below:
Remove the protective film
from the double-sided adhe-
sive strip at the ends of the LED
strip sections being connected.
Then firmly press the end of
the one LED strip onto the pins
on the connector
1
so they
pierce the strip conductor of
the LED strip.
Note:
Be sure to match up
the VGGD mark on the
connector with the VCC-
GND-GND-D0 and VCC-
GND-GND-DI mark on the
LED strip.
Then push a plastic clip
11
onto this new connection
from the top.
Note:
Be sure the plastic
clips lock in to establish a
secure connection.
Repeat this process to estab-
lish a contact for the other
end of the connector.
Note:
Unlike the LED strip,
the connector can be moved
in any direction:
The product
has delicate solder points.
Do not route the LED strip
around corners and do not
kink. The solder points may
otherwise be damaged, dis-
rupting the functionality of
the LED strip.
Summary of Contents for 279823
Page 3: ...VCC GND GND DI VCC GND GND D0 B 9 2 A 2 3 4 6 8 9 7 5 1...
Page 4: ...V G G D V G G D VCC GND GND DI VCC GND GND DO VCC GND GND DI VCC GND GND DO C 1 1 11 2 10...
Page 5: ...D Auto IC Set CS Flash Jump Meteor C3 C7 C16 w cw E 7 7 12...
Page 94: ...93 PT Com a troca do aparelho de acordo com DL 67 2003 o tempo de garantia se inicia novamente...
