LIVARNO LUX 14139304LE, Operation And Safety Notes

Page: 9 / 26

9 GB/IE/NI/CY
Safety /Preparation
Q
Preparations for use
Q
Fitting the light
Note: Prior to installation, verify there is a socket
nearby within reach of the included power cable
3
.
Note: The light can be adjusted to 2 light levels
using the ON / OFF switch
5
.
1. Measure up the wall or mounting surface for
drilling the holes. Use a spirit level to improve
accuracy.
2. Mark the distance for the mounting holes
1
or
11
.
3. Now drill the mounting holes (ø approx. 6 mm,
depth approx. 40 mm). Make sure that you do
not damage any electrical cables during this
operation.
4. Insert the supplied wall plugs
10
into the drilled
holes. Insert the supplied screws into the wall
plugs
10
and tighten them, stopping when they
project about 3 mm out of the wall or mounting
surface (fig. A).
5. Attach the light using the appropriate mounting
holes
11
or
1
to the screws.
6. When you have attached the light above the
assembly holes
11
, slide the light housing
9
to the left until it clicks into place.
7. Insert the light connector plug of the mains
lead
3
into the light connector socket
2
.
8. Insert the mains plug of the mains lead
4
into
a convenient mains socket. Your light is now
ready for operation.
Q
Connecting several
lights together
CAUTION!
Please ensure all under-cupboard lamps have been
connected with the connection cable
8
before
connecting the mains plug
4
to the mains socket.
Note: Make sure that you only connect a maximum
of 10 linked-up under-cabinet lights of the same
type to one socket.
Install up to 10 lights of the same model next
to each other. To do so, follow steps 1–5 of
the section called “Fitting the light”.
Note: Make sure that the distance between
the lights is not more than 15 cm.
Note: Make sure that the distance between
the lights is not less than 10 cm.
Remove the protective head guard
7
.
Insert the connecting cable
8
into the con-
necting socket
6
of the light.
Insert the second connection of the connecting
cable
8
into the socket
2
of the other light.
Insert the connection of the power cable
3
into the socket
2
of the outer, left-hand light.
Connect the mains plug
4
to the mains
socket. Your lights are now ready for opera-
tion.
Changing the light colour
To change the light colour, set the ON / OFF
switch
5
to the different levels.
‒ Level I = Warm white
‒ Level II = Cold white
Q
Switching On / Off
Switch the ON / OFF switch
5
to turn the
light on or off.
Move the ON / OFF switch
5
to the centre
position to switch the light off.
Q
Directing the light
Never change the direction of the light while
it is switched on.
RISK OF BURNS!
To prevent burns, be sure the light is switched
off and cooled down before touching it. The
illuminants become very hot.
Allow the light to cool down completely.
Turn the strip light
12
into the desired direction.
Preparations for use