2
3
6
THE WALKER
1. There are 3 positions on the Walker for different heights indicated on the suspension pegs.
Position 3 is tallest, 2 is medium, and 1 is shortest.
2. To adjust the height for Positions 1 and 2 start with the knobs beneath the Suspension Pegs
in the vertical position (unlocked). Push down on the vehicle to the desired number, then push
in and turn the knobs to the locked position (Fig. 18 & 19). The numbers on both sides of the
Rolling Base must match before child use. Confirm that the position is locked before child
use.
3. As the infant grows, move the Walker to the next position and lock it in place.
IMPORTANT NOTE: Remove child before adjusting to the next position. Push in and turn the
knobs beneath the Suspension Pegs to unlock the position.The knobs on the Rolling Base must
be in the vertical position (unlocked) to use the Walker. Walker is intended for use on hard,
level surfaces.
1. In Position 3, turn the knob on the Rolling Base to the “Lock” position to lock it in place as
shown. (Fig. 20)
IMPORTANT NOTE: The vehicle will ONLY bounce in Position 3 (unlocked).
Fig. 18
Fig. 19
Fig. 3
Fig. 3
SEAT CUSHION
1. Snap the Seat Backing into the back of the Walker. (Fig. 3)
2. Put the Seat Cushion into the opening of the Walker as shown. (Fig. 4)
3. Slip the back of the cushion over the Seat Backing. (Fig. 5)
Fig. 5
Fig. 5
Fig. 4
Fig. 4
Fig. 20
THE BOUNCER (STATIONARY ACTIVITY CENTER)
Fig. 8
Fig. 8
Fig. 7
Fig. 7
4. Slide the clips indicated “1” through the corresponding openings on the seat area. (Fig. 6 & 7)
5. Pull the clips through the underside of the Walker and fit them over the tabs. (Fig. 9)
6. Repeat this process for clips indicated “2” (Fig. 6) and then clips indicated “3” (Fig. 6 & 8) until all clips are
securely fastened.
IMPORTANT NOTE: To remove the cushion for washing, follow these steps in reverse order, leaving the Seat
Backing in place. See SEAT CUSHION WASHING AND DRYING INSTRUCTIONS on page 2.
1
1
2 2
3
3 3
3
Fig. 6
Fig. 6
seat underside
seat underside
Fig. 9
Fig. 9