INTRODUCTION
BEFORE YOU BEGIN
It’s time for some big, bouncing fun with the Little Tikes® Bounce House! This inflatable fun center
is soft, safe and provides hours of bounce-ability.
3. Lift the plug from the inflation/deflation opening on the front edge of
the unit. (Fig.1)
4. Place the hose of an electric pump (hose and pump not included) into the
opening. (Fig.2)
NOTE: Pump may be purchased at most hardware, sporting goods and other
retail outlets. Some pumps have inflate and deflate valves. Follow pump
instructions when attaching hose.
5. Inflate all chambers using 1 pc large air valves and 2 pcs small air valves.
(Fig.6)
CAUTION - DO NOT allow children to play on or in the unit until it is
fully inflated. Inflate the unit only to the point that it is firm but not hard
and wrinkles are still visible in the area of the welded seams. Maximum
inflation pressure is 0.3 psi, 0.0207 bars. Do Not over-inflate the unit.
Doing so may cause damage to the unit and bodily injury to the child should
the unit fail from over-inflation. Inflation time will depend upon the type of
pump being used.
6. Once the unit is inflated, remove the hose and close the
inflation/deflation opening by pressing the plug into the opening firmly
to assure there will be no air leakage. (Fig.3)
7. Open the entry into the Bounce House by pulling apart the hook-and-loop
closures. (Fig.4)
8. Allow one child at a time inside the Bounce House and securely close the
entry using the hook-and-loop closures. (Fig.5)
WARNING - Instruct the child to bounce in the center of the Bounce
House only. Bouncing close to the edges may cause a tipping hazard which
may damage the Bounce House and cause injury to the child.
9. Do Not allow the child to attempt to climb on the netting. Netting is
in place to assure child does not bounce out of the Bounce House area.
CONTENTS
(a) 1 Little Tikes® Bounce House
(b) 2 Repair Patches
Illustrations may vary from actual contents.
MINIMUM CLEARANCE ZONES
Make sure that there is a 2 m (6.6 ft..) obstacle-free zone
around the product.
2 m (6.6 ft.)
2 m (6.6 ft.)
2 m (6.6 ft.)
2 m (6.6 ft.)
2 m
(6.6 ft.)
2 m
(6.6 ft.)
An adult must set up and inflate the unit. Here’s how:
1. Remove the unit from its packaging and save the packaging to store it in when finished playing.
2. Unfold the unit in a flat area which has been cleared of all objects.
NOTE: DO NOT place the unit on an uneven surface or a surface which may allow the unit to slide.
Fig.1
Fig.2
Fig.3
Fig.4
(a)
(b)
Fig.5
Fig.6
2 pcs small
air valves
Deflation and Storage
An adult must deflate and store the unit. Here’s how:
1. Remove the child from the unit.
2. Remove the plug from the inflation/deflation opening.
3. Allow the unit to deflate.
Repairing a Puncture
In the event the Bounce House is accidentally punctured an adult must perform the following steps.
1. Deflate the item, clean the punctured area with water and allow it to dry.
2. Cut a portion of the patch allowing approximately 1 ½ inch of excess patch material on all sides of the
opening to be patched and round the corners.
3.
Remove the backing from the patch material, position the patch over the damaged area and smooth out
any bubbles with a paper towel.
4. Allow the item to sit for 30 minutes before re-inflating.
3
2