Little Giant TE-5.5-MDQ-SC Introduction Manual Download Page 1

1

INTRODUCTION

EN

This instruction sheet provides you with the information required 
to safely own and operate your Little Giant pump. Retain these 
instructions for future reference.
The Little Giant pump you have purchased is of the highest quality 
workmanship and material, and has been engineered to give you 
long and reliable service. Little Giant pumps are carefully tested, 
inspected, and packaged to ensure safe delivery and operation. 
Please examine your pump carefully to ensure that no damage 
occurred during shipment. If damage has occurred, please 
contact the place of purchase. They will assist you in replacement 
or repair, if required.

READ THESE INSTRUCTIONS CAREFULLY BEFORE 
ATTEMPTING TO INSTALL, OPERATE, OR SERVICE YOUR 
LITTLE GIANT PUMP. KNOW THE PUMP’S APPLICATION, 
LIMITATIONS, AND POTENTIAL HAZARDS. PROTECT 
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY 
INFORMATION. FAILURE TO COMPLY WITH THESE 
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/
OR PROPERTY DAMAGE!

DESCRIPTION

The TE-5.5-MDQ-SC is a magnetic drive aquarium pump designed 
to move water through an aquarium filtration system. The pump 
is designed to be installed external to the aquarium and filtration 
system, and is usually mounted below the aquarium in the cabinet 
that houses the filtration system (Fig. 1). 
The pump’s motor is thermally protected. The pump head parts 
are made of glass-filled polypropylene. The spindle shaft and 
thrust washers are ceramic. The impeller-driven magnet is coated 
ceramagnet A (barium ferrite) type ceramic with a carbon bushing. 
The O-ring seals are Viton®.
The pump is supplied completely preassembled and pretested 
from the factory. The power cord is not included.

SAFETY GUIDELINES

DANGER:

 To avoid possible electric shock, take special care 

when using aquarium equipment. 

Do not use to pump flammable or explosive fluids such as 
gasoline, fuel oil, kerosene, etc. Do not use in explosive 
atmospheres. Pump should be used with liquids compatible with 
pump component materials. 
The motor base of this pump could reach 140° F. When installing 
the pump, be certain that the mounting surface can withstand this 
temperature; otherwise, use a protective insulation between the 
surface and the base. 
Do not handle pump with wet hands or when standing on a wet or 
damp surface, or in water.
In any installation where property damage and/or personal injury 
might result from an inoperative or leaking pump due to power 
outages, discharge line blockage, or any other reason, use a 
backup system(s) and/or alarm.
Support the pump and piping when assembling and when 
installed. Failure to do so can cause piping to break, pump to fail, 
motor bearing failures, etc.
During normal pump operation, the motor case could reach 150° F; 
however, the motor is thermally protected to prevent excessive heat 
from damaging the unit.
If the pump falls into the water, DO NOT reach for it! Disconnect 
it from power, then retrieve it. If electrical components of the 
pump get wet, remove power from the pump immediately (non-
submersible equipment only).
Carefully examine the appliance after installation. Do not apply 
power if there is water on parts not intended to be wet.
Do not operate the pump if it is malfunctioning or if it is dropped 
or damaged.
Closely supervise any children near the pump when it is in use.
Unplug the pump from the outlet when not in use, before removing 
or installing parts, and before cleaning. 
Do not use the pump for anything other than its intended use.
Do not install or store the pump where it will be exposed to 
the weather or to temperatures below freezing. This can cause 
cracking or distortion that can destroy the pump.
If the pump is mounted on a tank, ensure that it is securely 
installed before operating it.
Read and observe all notices on the pump.
Do not attempt repairs yourself. Return the pump to Little Giant or 
an authorized service center.

ELECTRICAL CONNECTIONS

Refer to the schematic on the motor nameplate for 115V and 230V 
wiring connections.

MAGNETIC DRIVE 

AQUARIUM PUMP

MODEL 

TE-5.5-MDQ-SC

Franklin Electric Co., Inc.

P. O. Box 12010

Oklahoma City, OK 73157-2010

405.947.2511 • Fax: 405.947.8720

www.LittleGiantPump.com

[email protected]

DRIP LOOP
ANNEAU DE SECURITE
LAZO DE GOTEO

DRIP LOOP

ANNEAU DE SECURITE

LAZO DE GOTEO

AQUARIUM
AQUARIUM
ACUARIO

AQUARIUM
AQUARIUM
ACUARIO

FILTERS
FILTRES
FILTROS

PUMP

POMPE

BOMBA

PUMP

POMPE

BOMBA

SUMP

PUISARD

SUMIDERO

INTERNAL OVERFLOW AREA

SECTEUR INTERNE DE 

SURPLUS

ÁREA INTERNA DE 

CAPACIDAD EXCESIVA

INTERNAL OVERFLOW AREA

SECTEUR INTERNE DE SURPLUS

ÁREA INTERNA DE CAPACIDAD EXCESIVA

BIO
BIO
BIO

Figure 1

Summary of Contents for TE-5.5-MDQ-SC









Reviews: