Small Cape Cod Manual
Construction Manual © 2007 – 2008 Little Cottage Co. Page 2
7
8
9
10
11
12
This pictures shows the optional 4x4 runner, you will need
3 in order to have 1 under the joint. If you use only 2 the
floor will sag. Note: these aid in moving the building later,
but are optional, unless you are adding the deck & rail, then
you must add them or the child door will not clear the deck.
Turn the floor on the back with the ply
-
wood facing up. Make certain that the
ground is level where the floor sets or you
may have problems with the panels or the
roof.
Install section A BE SURE to install the trim toward the
center as shown! This is the trim for the small door. This
is the start for a 6x8 other sizes are slightly different. The
same basic structure is used. Refer to the wall layout
documents for the alphabetical order.
Make sure your panel is flush with the edge
of the floor. This is something that you
will need to check throughout the assembly
process.
Push the wall in as shown so the siding
is against the floor. This is again some
-
thing to do throughout the entire assembly
process.
Install header block B
