Z8F3224 ZMOTION Development Kit
UM029501-0321
SAMPLE APPLICATIONS
User Manual
12
Sample Application
Projects
There are four sample application projects included with the ZMOTIONL400ZCOG_1.0 installation.
•
o
Basic motion detection operation in Low Power Mode
•
o
Advanced motion detection operation in Low Power Mode
o
Refer to
“Serial Command Functions LP Rev x.pdf” included in the project folder
•
o
Basic motion detection operation in Normal Power Mode
•
o
Advanced motion detection operation in Normal Power Mode
o
Refer to “Serial Command Functions NP Rev x.pdf” included in the project folder
ZM_LP_Basic
This project uses the Low Power MCU configuration to provide motion detection with ZMOTION
Digital PIR validation.
The MCU stays in Low Power Stop mode until a motion event is detected by the analog PIR
interface. When the MCU wakes up it runs the ZMOTION Engine on the PIR signal to validate the
motion event.
When the motion event is validated, the status LED is flashed, and a message is sent via the
VCOM USB serial interface (connected to UART0 on the LP MCU).
Typical current consumption is <15uA @ 3.3V
Sliding SW4 to the LP position causes the NP MCU to be powered off and powers on the LP MCU.
The following status messages will be displayed on the terminal after power on.
