SAVE THESE INSTRUCTIONS
© Lithonia Lighting, Rev. [A]
RJ521309
Aeris Bollard Instru 05/06
SAVE THESE INSTRUCTIONS AND DELIVER TO OWNER AFTER INSTALLATION
Page 2
Refernece product warnings and instructions on Page 1 prior to beginning installation.
5. After wiring is done, the bollard should be carefully placed over the baseplate.
Make sure the bollard is vertically aligned and seated on the baseplate.
At this point, the 3/8" set bolts can be tightened (do not over tighten, over tightening will
cause stripping and void all warranties).
Each set bolt should be tightened a little at a time. Make one last check to see that the
set bolts are tight and the bollard is plumb, and sides are aligned with sidewalk or curb.
6. Next, loosen the top screw using a 5/32" Allen wrench. Note the top bolt
is captive and does not completely remove. Remove top cover and any plastic
protective covering. Lamp the fixture following lamp installation instructions below.
Replace the top cover making sure top cover is seated over lens before tightening top screw
(overtightening will void all warranties). It may be easier to fit the lens into the top, and
holding them as a unit, set them into place.
LAMP INSTALLATION
Prior to installing the lamp (not included) in the
fixture, check to make sure the lamp is the correct
source and wattage. Screw the lamp securely
into the socket, back it out one or two turns, then
screw lamp back in, making sure it is secure. This
procedure properly seats lamp in the socket.
FESTOON OUTLET (See Figure 1 above Right; Not to Scale)
Follow the instruction sheets suppied with the feston
outlet for proper installation.
Figure 1
