10. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain on switch housing
located to the RIGHT of the reverse switch
(labeled FAN). Start at the OFF position (no blade
movement). First pull will set the fan to HI.
Second pull will set the fan to MEDIUM. Third pull
will set the fan to LOW. Fourth pull will again set
the fan to OFF setting. If applicable, test light with
pull chain on switch housing located to the LEFT
of the reverse switch (labeled LIGHT). (
diagram 1
)
If fan and/or light do/does not function, please
refer to "Troubleshooting" section to solve any
issues before contacting Customer Service.
Turn fan completely off
before
moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important:
Reverse switch must be set either
completely UP
or
completely DOWN
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension(s) supplied or custom
pull chain extension(s) (sold separately) to end(s)
of the pull chain(s).
page 8
diagram 2
diagram 3
diagram 4
diagram 1
fan pull chain
extension
light pull
chain extension
motor housing
reverse
switch
