page 8
11. Light Kit Assembly (optional).
WARNING:
Failure to disconnect power
supply at main panel prior to light kit assembly
may result in serious injury.
If you wish to use your fan with a light kit:
Remove three screws from switch housing.
Remove switch housing plate from switch
housing.
Locate
BLUE
and
WHITE
wires in the switch
housing labeled FOR LIGHT. Remove and discard
cardboard label and plastics that hold these two
wires together.
If your light kit is to be mounted directly to switch
housing, remove three screws from light kit. Make
wire connections as described below.
If your light kit is to be attached by a threaded
rod, remove the hex nut and washer from light kit.
Punch center cap out of switch housing plate with
a screwdriver. Push wires from light kit through
center hole and screw switch housing plate onto
threaded rod followed by the previously removed
washer and hex nut. Tighten hex nut over washer
for a secure fit. Make wire connections as
described below.
Connect the
WHITE
wire from the light kit to the
WHITE
wire from the switch housing. Connect the
BLACK
wire from the light kit to the
BLUE
wire
from the switch housing. Use wire nuts when
making the connections. Attach light kit to fan by
securely tightening the three screws that were
previously removed.
Attach glass shades to light kit using the provided
hardware. If you are installing a bowl fixture, the
bulbs must be installed first.
Lamp with the light kit's specified bulbs. If you are
installing a halogen bulb, be sure not to handle
glass directly with your fingers as oil from the skin
shortens the life of the bulb.
motor housing
switch housing plate
switch housing
switch housing
light kit
