page 7
10. Light Kit Assembly (Optional). (cont.)
Remove 3 screws from light kit fitter. Locate
BLUE
(or
BLACK
) and
WHITE
wires in the switch housing
labeled FOR LIGHT KIT CONNECTION. Remove and
discard plastic that holds these 2 wires together.
Connect
WHITE
wire from switch housing to
WHITE
wire from light kit fitter. Connect
BLUE
(or
BLACK
)
wire from switch housing to
BLACK
wire from light kit
fitter. Be sure that molex connections snap together
securely.
Align holes in light kit fitter with holes in switch
housing. Attach light kit fitter with 3 screws that were
previously removed. Securely tighten all screws.
Attach glass shades to light kit fitter with
thumbscrews provided in one of the hardware packs.
Do not overtighten thumbscrews as glass may crack or
break.
Install 4 candelabra base 60 watt max. bulbs (sold
separately).
Important
: When replacing bulbs, please allow bulb(s)
and glass shade(s) to cool down before touching.
11. Testing Your Fan.
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and wall
switch (if applicable). Test fan speeds with the pull
chain directly opposite the reverse switch. Start at the
OFF position (no blade movement). First pull will set
the fan to HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull will
re-set the fan to OFF setting. Test light kit with the
pull chain in the middle. (Refer to
diagram 1
.) If fan
and/or light do (does) not function, please refer to
"Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the middle
position (
diagram 4
), fan will not operate.
Attach pull chains extensions provided or custom pull
chain extensions (sold separately) to ends of pull
chains.
motor housing
switch
housing
glass
shade
bulb
thumbscrew
light kit fitter
pull chain
extensions
reverse
switch
thumbscrew
molex
connections
diagram 2
diagram 3
diagram 4
diagram 1
