page 7
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan
speeds with the pull chain labeled FAN. Start at
the OFF position (no blade movement). First pull
will set the fan to HI. Second pull will set the fan
to MEDIUM. Third pull will set the fan to LOW.
Fourth pull will again set the fan to the OFF
setting. Test light with the pull chain labeled
LIGHT. (
diagram 1
) If fan and/or light do (does)
not function, please refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Turn fan completely off
before
moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- LEFT position in summer (
diagram 2
)
- RIGHT position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan to function. If the reverse switch is set in
the
middle
position (
diagram 4
), fan will not
operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to the end
of the pull chains.
10. Testing Your Fan.
glass shade
pull chain
extensions
rubber ring
thumbscrew
9. Light Kit Assembly.
Install 1 medium base 6.5 watt max. LED
bulb (included).
IMPORTANT
: When replacing bulb,
please allow bulb and glass shade to
cool before touching.
Partially loosen 3 thumbscrews at
bottom of motor housing and raise glass
shade to motor housing. Secure glass
shade with thumbscrews. Be sure
thumbscrews make contact with rubber
ring on glass shade,
but do not
overtighten thumbscrews as glass may
crack or break
.
reverse switch
bulb
motor
housing
diagram 2
diagram 3
diagram 4
diagram 1
