8. Canopy Assembly.
page 6
canopy
hanging
bracket
canopy
screw
7. Wiring.
code switches
remote control transmitter
black
black
black
from receiver
from fan
from ceiling
from receiver
white
white
blue
blue
black supply wire
ground (green
or bare)
white supply wire
white
AC IN N
AC IN L
remote
control
receiver
receiver
black
white
ground
(green or bare)
battery
battery cover
*
antenna
Temporarily raise canopy to hanging bracket to
determine which 2 screws align with slotted
holes in canopy, and then lower canopy and
partially loosen
these 2 screws.
Remove
the
other
2 screws and set aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist
canopy to lock. Re-insert the other 2 screws and
secure all screws with Phillips screwdriver.
Use a ballpoint pen or a small screwdriver to set
the code switches for the remote control
transmitter and remote control receiver so that
they match. Factory setting is pre-set and not
recommended for use. If your remote control
interferes with other appliances, change to
another matching code on the remote control
transmitter and receiver.
In order for the remote control to operate, one
9-volt battery (sold separately) should be
installed in the remote control transmitter.
After installing the battery, re-attach the
battery cover.
CAUTION
:
Be sure outlet box is properly
grounded and that a ground wire (
GREEN
or
Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with
electrical wiring or if the house/building wires are
different colors than those referred to in the
diagram to the right, please use a qualified
electrician.
Wire the receiver with wire connectors
provided as shown.
Tip:
While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently insert receiver (switch side down) into
hanging bracket and carefully push taped wire
connectors into outlet box. Let antenna rest
outside of hanging bracket.
