7. Canopy Assembly.
8. Blade Assembly.
motor housing
blade arm
blade
page 6
plastic
motor
lock
Time Saver
: Washers for blade screws can be set
on each blade screw prior to installing blades.
If you are installing the fan indoors,
use the
wood blades.
If installing the fan in DAMP location
, use the
weatherproof ABS blades.
WARNING:
Only the weatherproof ABS blades are
approved for use in damp location. Using the
wood blades in a damp location will damage the
blades.
Locate 15 blade attachment screws and washers
in one of the hardware packs. Check labels on
hardware packs for blade attachment screws and
washers and make sure to use the correct blade
attachment screws and washers for the blades
you are using.
NOTE: Blade attachment screws for
ABS weatherproof blades are slightly longer
than the blade attachment screws for wood
blades.
Hold blade arm up to blade and align
holes. Insert 3 blade attachment screws (along
with washers) with fingers first and then tighten
screws securely with a Phillips screwdriver. Repeat
for the remaining blades.
Remove blade arm screws and lock washers from
fan motor and set aside. If plastic motor locks are
installed with blade arm screws, discard plastic
motor locks (
save blade arm screws and lock
washers to secure blade arms
). Align blade arm
holes with motor screw holes and attach blade
arm with lock washers and blade arm screws.
Before securing screws permanently, repeat with
remaining blade arms. Secure all screws.
lock washer
blade arm screw
blade attachment
screws and washers
hanging bracket
canopy
screw
screw
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed,
and then tighten both screws securely.
